Smt picking belt is how to produce it？

  SMT picking belt series: picking products are mainly four series (for 8mm, 12mm, 16mm, 24mm, 32mm with):

 1, single-sided material belt (multi-type): the general with the feeder clamp, access material copper buckle use, skilled operation of the staff can not use the clamp and directly with the four sides of the tape with adhesive tape, this price relative Cheap.

 2, double-sided belt (multi-series) (single, bilateral hole positioning), the use of both sides of the material and the ribbon with the row of holes corresponding to the yellow material with the tape on the film corresponding to complete, to paste, Moderate

 3, all-round belt (multi-series), so that the material becomes more reasonable, fast; three side-type belt (Panasonic) to change the Panasonic machine can not renew the history of the electronics manufacturing enterprises to create more interest.

 4, special picking belt (multi-series),

SMT double-sided film for 8mm, 12mm, 16mm, 24mm

  Through the use of materials, can be for the majority of electronics manufacturing enterprises to bring the following advantages:

 1, is a great increase in production efficiency, if the downtime pick up, each time spent about 2 minutes, this is still fast, a machine running a minute count 8 yuan, which wastes 2 * 8 = 16 Yuan; if the belt with the need to save this time, spent two pieces with only 0.4 yuan.

 2, is a great way to avoid waste of material: to avoid the material is too short and can not be used on the machine and discard, can all use the remaining materials.

 3, is to reduce the machine Feida and other mechanical losses; reduce the machine frequently stop, open, to avoid flying up frequently and other movements, can extend its service life.

 4, is to avoid some of the switch cover may cause human accidents.

(M-ESD), bright black - anti-static (G-ESD), transparent green - anti-static (L-), anti-static (M-ESD) ESD)